8400-M022-O1 Rev K Model 190 Indicator
This means that it is very important that the DEFAULTS jumper NOT be left in place on the
board for normal operation and should only be used if trying to recover a module with
incorrect settings.
At this point, 190-WIFI should continue with normal operation using the default
configuration.
NOTE: The DEFAULTS jumper will launch the configuration web page if set briefly after
power up.
Web Configuration Parameter Descriptions – Access Point
The configuration web page in the 190-WIFI module allows the module to be configured as
either an access point or to connect to an existing network. To accomplish this, a new
parameter has been added on the web page “Network Mode”.
To Next Page
Loading...
