8400-M022-O1 Rev K Model 190 Indicator
Network Mode
This parameter allows the 190-WIFI module to be configured as either an access point,
or to connect to an existing network.
To set up the 190-WIFI module as an access point, set the mode to “Server (SoftAP).
Access Point SSID
Enter the SSID of the access point you wish to connect to here. If no access point exists
with the SSID that is entered, then the 190-WIFI module will attempt to start an access
point with the entered SSID.
Security Mode
When the “Network Mode” is set to “Server (SoftAP)” mode, then this sets the security type
that will be used to connect to the module acting as an access point. The password used by
the connecting device must match the password set on the configuration web page to
connect to the module.
IP Address
Enter the static IP address of the 190-WIFI module here.
Network Mask
Enter the desired Netmask here.
Gateway IP Address
Enter the default gateway IP address here.
Enable DHCP Server (recommended)
When “Server (SoftAP)” mode is active, the “Enable DHCP Server” checkbox will enable
the DHCP server to assign addresses automatically to connecting devices.
NOTE: If this check box is unchecked in this mode, it will be important to set static IP
addresses in the devices connecting to the WIFI module that is compatible with the settings
that are set in the module itself.
Once all settings have been entered, click “Save & Reboot” at the bottom of the webpage
to save the parameters.
NOTE: It is very important not to press “Enter” before all of the configuration
settings have been properly entered. Pressing “Enter” before entering in all
of the appropriate settings will submit the information and may put the device
into a state where it cannot be connected to. If this happens, it may be
necessary to isolate the 190-WIFI module from wireless signals and use the
DEFAULT jumper to restore the network to a known configuration.
To Next Page
Loading...
