EasyManua.ls Logo

Cardioline ECG100+ - Wireless Transmission Safety Considerations

Cardioline ECG100+
84 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ECG100+ - ECG200+ - ECG100S - ECG200S
2. SAFETY INFORMATION
Atmospheric pressure .....................
After using the device on battery power, always reconnect the power cable. This will guarantee that
the batteries are recharged automatically the next time the device is used.
2.1. Wireless Data Transmission
The device can be equipped with an optional wireless data transmission module (WLAN mobile), that uses
radios to transmit data to an application that can receive them.
Due to the nature of radio transmissions, it is possible that, due to the characteristics of the environment
where the device is located, some other RF sources may interfere with the transmission generated by the
device.
Cardioline SpA has tested the coexistence of the device with other devices that can interfere such as devices
using WLAN, Bluetooth radio and/or cell phones. Although the current technology allows a very successful
rate of transmission, it is possible that in some rare occurrences, the system may not perform at its best
resulting in a “failed transmission”. When this occurs, patient data will not be erased from the device nor
stored in the receiving application, ensuring that partial or corrupted data are not made available to the
receiving station. If the failure mode persists the user should move to a position where the RF signals may
propagate better and allow successful transmissions.
2.2. Wirless Option
Wireless options transmit at 2.4 GHz. Other nearby wireless devices may cause interference. If possible,
move or turn off other devices to minimize potential interference.
The following table shows the channels allocated in different geographic areas in the world. Please consult
with your IT personnel in order to set the device on the proper channels.
Specification
Description
Technology
Compliant withIEEE 802.11n, IEEE 802.11g and IEEE 802.11b
standards
Interface Type
USB2.0/1.1
Security
64/128bit WEP encryption
WPA/WPA2 and WPA -PSK/WPA2-PSK encrytions
Wi-fi Protected setup(WPS)
RF Frequency
2,412 to 2,462MHz (North America)
2,412 to 2,472MHz (Europe)
2,412 to 2,484MHz (Japan)
Operating Frequency
FCC 2412-2462MHz (Ch1-Ch11)
ETSI 2412-2472MHz (Ch1-Ch13)
RF Power
11n mode: 13dBm
11g mode: 15dBm
11b mode: 18dBm

Table of Contents