Carrier ChillerVu - To Use the Auto-Off-On Switches

Wiring inputs and outputs
Carrier® ChillerVu™
(OPN-PSM-MPCXPE) Carrier Proprietary and Confidential CARRIER CORPORATION ©2017
Installation and Start-up Guide 21 All rights reserved
To use the Auto-Off-On switches
You can control an output using the
Auto-Off-On
switch.
Set the switch to...
To...
On
Turn on the output.
Off
Turn off the output.
Auto
Let the control program control the output.
The potentiometer, located between the
Auto-Off-On
switch and the jumper, allows you to manually control the
output level of an analog output. Place the
Auto-Off-On
switch in the
On
position, then turn the potentiometer
counterclockwise to reduce the output, or clockwise to increase the output.
WARNING!
The output potentiometer is NOT used for binary output channels. For a binary output, turn the
potentiometer clockwise until it stops (maximum output) and leave it in this position. Failure to do so may result in
relay-chattering or failure of the relay to energize when the
Auto-Off-On
switch is in the
On
position.