62-61753-21
NO ACTION TAKEN, REMOVE CARD
A Program PC Card has been inserted into the PC Card slot, and no
key presses have been made to install the program into the micro-
processor. The PC Card may be safely removed from the slot.
There are no active alarms in the microprocessor Alarm List.
NO DATA ON CARD, REMOVE CARD
A Program or Configuration PC Card has been inserted into the PC
Card slot, and no valid data is present on the PC Card. The PC Card
may safely be removed from the unit.
NO DATA TO COPY, REMOVE CARD
A Download PC Card has been inserted into the PC Card slot, and
there is no valid data in the Data Recorder to copy onto the PC Card.
The PC Card may safely be removed from the unit.
There are no inactive alarms in the Alarm List
NO INSTALLS LEFT, REMOVE CARD
An Option PC Card has been inserted into the PC Card slot, and all
install options have been used. The PC Card may safely be removed
from the unit.
OLD INTELLISETS-USE REEFERMAN
The IntelliSets that are on the Configuration PC Card were written
with too old of a PC Program, like ServiceManager. The software in
the micro requires IntelliSets to be written to the Configuration PC
Card using ReeferManager. Rewrite the information to the card using
ReeferManager, then use it in the microprocessor again
OLD SW:CANNOT LOAD-REMOVE
CARD
A Program PC Card has been inserted into the PC Card slot, and the
major version of the program on the PC Card is an older version than
what is already loaded in the microprocessor. Software with older
major versions can not be loaded into the microprocessor. Remove
the PC Card. (Refer to Section 5.3 for software version description.)
OLD SW, = TO LOAD, TO CANCEL
A Program PC Card has been inserted into the PC Card slot, and the
minor version of the program on the PC Card is an older version than
what is already loaded in the microprocessor. Press the = key to load
the older program. (Refer to Section 5.3 for software version descrip-
tion.)
START/RUN-OFF switch is OFF, the PC mode Jumper or download
cable is connected and should be removed.
Preventative Maintenance is now due on the unit.
Press the UP or DOWN ARROW key to scroll through the Data List.
PRESS TO VIEW SETTINGS
Press the UP or DOWN arrow key to scroll through Functional Pa-
rameter Settings.
PRESS TO VIEW PRINT MENU
Press the UP or DOWN arrow key to view the Strip Print setup menu.
PRESS = TO MARK TRIP START
Press the = key to mark the start of the trip in the Data Recorder.
Press the = key to begin pretrip tests.
PRESS TO VIEW INTELLISET
Press the UP or DOWN arrow key to view IntelliSet list. This mes-
sage will appear after IntelliSets are installed into the microprocessor,
and the unit can not be started until an IntelliSet is selected.
The Pretrip test is completed, and some of the pretrip tests did not
pass. Check the Alarm List for pretrip alarms.
Some of the pretrip tests did not pass and the pretrip was not com-
pleted. Check the Alarm List for pretrip alarms.
All of the pretrip tests were ok.
Pretrip has been stopped by user.
PRODUCTSHIELD: HIGH AIR ON
The unit is operating in ProductShield High Air which overrides nor-
mal unit speed operation. Refer to Section 4.6.3.
The unit is operating in ProductShield Winter which overrides normal
unit operation. Refer to Section 4.6.3.
To Next Page
Loading...
