92
(
Selecting one of standard Settings)
1 From the mass display, press the [CAL] key
repeatedly until the [intFACE] display appears.
Press the [O/T] key. The display shows “iF;F1”
2 If necessary, press the [CAL] key repeatedly
until the desired standard setting display appears.
Then, press the [O/T] key.
3 Press the [POWER] key repeatedly to return to
the mass display.
14.3.3 User Setting
The user setting allows individual setting for each item in communication settings.
(
Making user settings)
1 In mass display, press the [CAL] key repeatedly
until “intFACE” appears and press the [O/T]
key. “iF:F1” appears.
2 Press the [CAL] key repeatedly until “iF: USEr”
appears and press the [O/T] key. “io.b:* ***”
appears (communication speed settings).
(**** shows the current setting; 2 to 4 characters,
the same applies hereafter.) After this, pressing
the [CAL] key alternates the display in this order:
“io.d: ****” (delimiter setting), “io.P; *:**”
(parity setting), “io.S: ****” (stop bit setting),
“io.F: ****” (data format setting), and
“io.H: ****” (handshake setting).
3 When the item to be set appears, press the [O/T]
key. (Refer to the following selections thereafter.)
(When F1 is selected)
(When F1 is selected)
(Example)
(Example)
(Example)
(Example)
(Example)
(Example)
Displays of all the items
To Next Page
Loading...
Need help?
General
