CAS CAU Series - Date Printout Setting

6
4
10.4.3 Date Printout Setting
This setting determines whether or not the date and time on the balance’s built-in clock is
printed out along with the calibration report.
1 From mass display, press the [CAL] key
repeatedly until “SEttinG” appears.
Press the [O/T] key. “CAL dEF” appears.
2 Press the [CAL] key repeatedly until “Prtdt:**”
appears. The ** positions show the current
setting, “on” when set (print) and “oF” when
unset (do not print).
3 To change the setting, press the [O/T] key
when “Prtdt:**” is showing. The display will
show“Prdt-on”. (The “:” becomes “-”)
4 From this point, every time the [CAL] key is
pressed, the display will switch between
“Prdt-oF” and “Prdt-on”. Here, when the
current setting is displayed, the stability mark
(¨) appears.
5 To change the setting, press the [O/T] key
when the desired setting appears, or
6 Press the [POWER] key to return to
“Prtdt: **” without changing the setting.
7 Press the [POWER] key again to return to the
mass display.
(When OFF)
(Example)
(When ON)
(Example)
(Example)
(When ON)
(When OFF)
(Example)
Setting
check
During
setting
During
setting
Setting
check