95
14.3.3.6 Handshake settings
(1) The display changes from “io.H: ****” to “F-dF1”.
to “H-oFF”. Pressing the [CAL] key cycles through the available settings.
The stability mark (¨) appears, when the current setting is displayed.
Display during
setting
H-oFF H-Soft H-HArd H-tr
Setting specifics No handshake
Software
handshake
Hardware
andshake
Timer
handshake
When the desired setting appears, press the [O/T] key.
Press the [POWER] key to return to “io.H: ****”.
14.4 Decimal Point Symbol in Output Data
The CAUW-D/CAUW/CAUX/CAUY series offers choice of decimal point symbols in the
outputted data to a computer or an electronic printer. The decimal point can be expressed
with either “.” (period) or “,” (comma) depending on your preference.
Note that the decimal point expression on the balance display is always with “.” (period).
1 From the mass display, press the [CAL] key
repeatedly until “SEttinG” appears, press the
[O/T] key. “CAL dEF” will appear.
2 Press the [CAL] key repeatedly until “dECPt: **”
appears (** indicates the current setting.
“Pr” for period, “Co” for comma.
3 Press the [O/T] key. The display shows
“dECPt-Co” and after this, pressing the [CAL] key
switches the displays between “dECPt-Co” and
“dECPt-Pr”. When the current setting is displayed,
the stability mark (¨) appears. To change the
setting, press the [O/T] key when the desired
setting appears, or
4 Press the [POWER] key to return to “dECPt:**”
without changing the setting.
5 Pressing the [POWER] key again returns to the
mass display.
(when period is selected)
(when period is selected)
Setting
check
(Example)
(Example)
During
setting
(when comma is selected)
(when comma is selected)
During
setting
(Example)
(Example)
Setting
check
To Next Page
Loading...
Need help?
General
