4
9.3 Turning the Backlight On and Off
(CAUW series only) (Not for CAUW-D)
The CAUW series is equipped with a backlight for the display to allow easy viewing
Regardless of the surrounding lighting conditions. The backlight can be switched on and off.
1 Press the [CAL] key repeatedly from the mass
display until “SEttinG” appears.
Press the [O/T] key. “CAL dEF” appears.
2 Press the [CAL] key and the display shows
“LiGHt:**”. The ** position shows “on”
for on, and “oF” for off.
3 To change the settings, press the [O/T] key
when the “LiGHt:**” appears. The display
shows “LiGt-on”.
4 From that point, every time the [CAL] key is
pressed, the display switches between
“LiGt-on” (on), and “LiGt-oF” (off). Here,
when the current setting is displayed,
the stability mark (¨) appears.
5 Press the [O/T] key when the desired setting
appears, and the display will return to
“LiGHt:**”, indicating the new setting.
6 If no change is required, press the [POWER]
key to return to “LiGHt:**”.
7 Press the [POWER] key repeatedly to return
to the mass display.
When backlight is used for normal operations, any required “warm-up”
should also by performed with backlight on. Leave the balance in mass display,
rather than “STAND-BY” for the required warm-up period. (See 4.4)
(When OFF)
(When ON)
(When OFF)
(When OFF)
(Example)
(Example)
(Example)
(Example)
During
setting
During
setting
Setting
check
Setting
check
To Next Page
Loading...
Need help?
General
