4
8.3 Time
1 From the mass display, press the [CAL] key
repeatedly until “SEttinG” appears.
Press the [O/T] key.
“CAL dEF” will appear.
2 Press the [CAL] key repeatedly until
“t-HH.MM” appears (HH and MM are each
two digits representing hour and minute,
respectively), and press the [O/T] key.
3 In the upper part of the display, the MEMU
symbol and the # symbol appear indicating
number entry status. Also, the current time
setting appears as [HH.MM.SS] (HH is hours,
MM is minutes, and SS is seconds) with the
leftmost digit blinking.
4 Pressing the [UNIT] key increases the blinking
digit by one. Pressing the [PRINT] key moves
the blinking digit one place to the right.
5 Press the [O/T] key when the desired time is
shown in the display. The built-in clock will
be set.
6 Press the [POWER] key repeatedly to return
to the mass display.
(Example)
(Example)
(Example)
(2:25PM)
To Next Page
Loading...
Need help?
General
