Casio ClassPad 300 - Page 362

20021201
Calculation Result Output
µ 1 ≠ µ 2: test condition
z: z value
p: p-value
o1:mean of sample 1 data
o2:mean of sample 2 data
x1 σ n-1: standard deviation of sample 1 (Displayed only for list format.)
x2 σ n-1: standard deviation of sample 2 (Displayed only for list format.)
n1: size of sample 1
n2: size of sample 2
1-Prop Z Test
Command: OnePropZ Test䡺
Description: This command tests whether successes achieve a fixed proportion.
A 1-Prop Z Test is used for normal distribution.
Z =
n
x
n
p
0
(1– p
0
)
– p
0
p0 : expected sample proportion
n : sample size
Command Syntax
“Prop condition”, p0 value, x value, n value
Definition of Terms
Prop condition: sample proportion test condition (“≠” specifies two-tail test, “<”
specifies lower one-tail test, “>” specifies upper one-tail test.)
p0 : expected sample proportion (0 < p0 < 1)
x : sample value (integer, x > 0)
n : sample size (positive integer)
Input Example:
OnePropZTest “≠”,0.5,2048,4040
Calculation Result Output
Prop≠0.5: test condition
z: z value
p: p-value
ˆp : estimated sample proportion
n: sample size
7-9-4
Tests