20021201
15-2-3
Connecting the ClassPad to Another Device
Connecting to a Computer (USB)
By running ProgramLink software that comes with ClassPad on your computer, you can
transfer ClassPad data to your computer.
See the user documentation that comes with ProgramLink for information about how to use it.
• For information about ProgramLink minimum computer system requirements, see the user
documentation that comes with ProgramLink.
k Required Hardware
ClassPad: 1 unit
Computer (with ProgramLink installed): 1
Special SB-300 Cable: 1
u ClassPad Operation
(1) Turn off the ClassPad and computer.
(2) Connect one end of the special cable that comes with ProgramLink to the USB port of
your computer.
• See the user documentation that comes with the ProgramLink software for details
about how to connect the cable to your computer.
(3) Connect the other end of the special cable as shown below.
• For information about what you should do to actually transfer data, see the user
documentation that comes with ProgramLink.
20030601
To Next Page
Loading...
Need help?
General
