20021201
Break dialog box
1-5-11
Built-in Application Basic Operations
Example: To pause a graphing operation and then resume it
u ClassPad Operation
(1) Use the Graph & Table application to draw a graph.
• For details about graphing, see “Chapter 3 – Using the Graph & Table Application”.
(2) While the graph is being drawn, press the K key.
• This pauses the draw operation and displays on
the right side of the status bar.
(3) To resume the operation, press the K key again.
• This resumes the draw operation, which continues
until the graph is complete.
k Terminating an Operation (Break)
Pressing the c key while an expression processing, graphing, or other operation is
being performed terminates the operation.
Example: To terminate a graphing operation
u ClassPad Operation
(1) Use the Graph & Table application to draw a graph.
• For details about graphing, see “Chapter 3 – Using the Graph & Table Application”.
(2) While the graph is being drawn, press the c key.
• This terminates the draw operation and displays the Break dialog box, indicating the
Break state.
Draw is paused at the point
where K is pressed.
(3) To exit the Break state, tap the [OK] button.
• This returns the ClassPad to its status before you started the graphing operation.
To Next Page
Loading...
