56
Advanced function Description
REMOTE CONTROL 1 /
REMOTE CONTROL 2
WATER COOLER OPTIONAL
WIRE FEEDER 1 OPTIONAL
REMOTE CONTROL 1 RC OPTIONAL
TORCH TYPE 1 400A H2O
SAFETY CALIBRATION CODE 1 013
WIRE FEEDER 2 ABSENT
REMOTE CONTROL 2 RC OPTIONAL
TORCH TYPE 2 400A H2O
SAFETY CALIBRATION CODE 2 013
WATER COOLER OPTIONAL
WIRE FEEDER 1 OPTIONAL
REMOTE CONTROL 1 RC OPTIONAL
TORCH TYPE 1 400A H2O
SAFETY CALIBRATION CODE 1 013
WIRE FEEDER 2 ABSENT
REMOTE CONTROL 2 RC OPTIONAL
TORCH TYPE 2 400A H2O
SAFETY CALIBRATION CODE 2 013
DISABLED - Means that REMOTE CONTROL 1-2 must not be managed by the plant,
even if it is connected up.
OPTIONAL - This means that REMOTE CONTROL 1-2 can or cannot be connected to
the welding plant. If it is disconnected while the plant is running, no alarm is raised.
OBLIGATORY - This means that it is obligatory for REMOTE CONTROL 1-2 to be
connected to the welding plant, even when the plant is switched on.
A error condition is generated when:
• Switching on or at any other time if the welding plant does not detect the presence (only
if set as obligatory).
• During normal operation, if the remote control is disconnected.
WARNING: For indications on use and functioning of the ANALOGIC RC remote
control see the manuals for the welding machine and the wire feeder, enclosed with the
documentation.
TORCH TYPE 1 / TORCH TYPE 2
WATER COOLER OPTIONAL
WIRE FEEDER 1 OPTIONAL
REMOTE CONTROL 1 RC OPTIONAL
TORCH TYPE 1 400A H2O
SAFETY CALIBRATION CODE 1 013
WIRE FEEDER 2 ABSENT
REMOTE CONTROL 2 RC OPTIONAL
TORCH TYPE 2 400A H2O
SAFETY CALIBRATION CODE 2 013
WATER COOLER OPTIONAL
WIRE FEEDER 1 OPTIONAL
REMOTE CONTROL 1 RC OPTIONAL
TORCH TYPE 1 400A H2O
SAFETY CALIBRATION CODE 1 013
WIRE FEEDER 2 ABSENT
REMOTE CONTROL 2 RC OPTIONAL
TORCH TYPE 2 400A H2O
SAFETY CALIBRATION CODE 2 013
Used to set the TORCH TYPE 1/2 that will subsequently be connected to the welding
plant. This operation must be done in order to size the plant correctly and as a result, the
welding parameters.
SAFETY CALIBRATION CODE 1 /
SAFETY CALIBRATION CODE 2
WATER COOLER OPTIONAL
WIRE FEEDER 1 OPTIONAL
REMOTE CONTROL 1 RC OPTIONAL
TORCH TYPE 1 400A H2O
SAFETY CALIBRATION CODE 1 CALIBRATION
WIRE FEEDER 2 ABSENT
REMOTE CONTROL 2 RC OPTIONAL
TORCH TYPE 2 400A H2O
SAFETY CALIBRATION CODE 2 CALIBRATION
WATER COOLER OPTIONAL
WIRE FEEDER 1 OPTIONAL
REMOTE CONTROL 1 RC OPTIONAL
TORCH TYPE 1 400A H2O
SAFETY CALIBRATION CODE 1 CALIBRATION
WIRE FEEDER 2 ABSENT
REMOTE CONTROL 2 RC OPTIONAL
TORCH TYPE 2 400A H2O
SAFETY CALIBRATION CODE 2 CALIBRATION
By turning ENCODER KNOB - DX, go to CALIBRATION value to read and check instruments
values (voltmeter and ammeter) of the power source.
NOTE: At the end of such operation, before restarting welding, you should put back the
previous value by always turning the ENCODER K
NOB - DX.
To Next Page
Loading...
