2
GB
INSTALLATION
RX DC X-RAY UNIT
4.12 Completion of wall-mounting plate and holder for handheld. ...................................................... 23
5. FACTORY SETTINGS .......................................................................................................... 26
6. TURNING ON AND FUNCTIONING OF THE DEVICE ..................................................... 26
6.1 Turning on the basic X-ray unit .................................................................................................... 26
6.2 Handheld Functions ..................................................................................................................... 27
6.3 Handheld display functions ......................................................................................................... 28
6.4 Use of handheld .......................................................................................................................... 29
6.5 X-RAY unit stand-by time .............................................................................................................. 30
6.6 Checking the parameters ............................................................................................................. 30
6.7 Factory settings ............................................................................................................................ 31
6.8 Positioning the X-ray head .......................................................................................................... 31
6.9 Position of the x-ray plate or sensor ............................................................................................. 32
6.10 Procedure to be followed when taking the x-ray ........................................................................... 33
7. TECHNICIAN AND USER SETUP MENU ......................................................................... 33
7.1 Setting the safety unlock mode .................................................................................................... 35
7.2 Setting the operating mode .......................................................................................................... 35
7.3 Setting the type of movable collimator ......................................................................................... 36
7.4 Calibrating the X-ray head ........................................................................................................... 36
8. ADJUSTING THE ACTUATOR UNIT (ONLY RX DC WITH "BALL END SOCKET
JOINT") ................................................................................................................................. 37
9. ELECTRONIC BOARDS ...................................................................................................... 40
9.1 Power Board (Code 97661585) .................................................................................................... 40
9.2 Basic X-ray head control card (Code 97661586) ........................................................................ 42
9.2.1 Replacing the basic X-ray head control card ................................................................... 44
10. X-RAY HEAD ........................................................................................................................ 46
10.1 Handheld unit-X-ray head association .......................................................................................... 46
10.2 Setting the X-ray head in combination mode ................................................................................ 47
10.3 Send the recognition signal from the handheld unit to the X-ray head ......................................... 47
To Next Page
Loading...
