Small-Scale Deployment Installation
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Centrally Managed Administration Guide|34
6. On the Trusted Communication page, configure how the Security Management Server
and the Quantum Spark appliance authenticate each other and click Next:
n
If on the previous General Properties page you selected Static IP address:
a. In the Authentication section, select Initiate trusted communication
securely by using a one-time password or Initiate trusted communication
without authentication (less secure).
b. If you selected Initiate trusted communication securely by using a one-time
password, enter a one-time password and confirm it.
This password is only used to establish the initial trust. After it is established,
trust is based on security certificates.
Important - This password must be identical to the one-time
password you define for the appliance in the First Time
Configuration Wizard.
c. In the Trusted Communication section, select Initiate trusted
communication automatically when the Gateway connects to the Security
Management server for the first time or Initiate trusted communication
now.
d. Click Connect.
A status window appears.
n
If on the previous General Properties page you selected Dynamic IP address:
a. In the Gateway Identifier section, select one identifier: Gateway name, MAC
address, or First to connect.
b. In the Authentication section, select Initiate trusted communication
securely by using a one-time password or Initiate trusted communication
without authentication (less secure).
c. If you selected Initiate trusted communication securely by using a one-time
password, enter a one-time password and confirm it.
This password is only used for establishing the initial trust. After it is
established, trust is based on security certificates.
Important - This password must be identical to the one-time
password you define for the appliance in the First Time
Configuration Wizard.
To Next Page
Loading...
