Small-Scale Deployment Installation
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Centrally Managed Administration Guide|40
7. Follow the steps to configure the first Quantum Spark appliance with the First Time
Configuration Wizard.
Important:
n
The WAN interface:
When you create the cluster object in SmartConsole in Wizard Mode, it
assumes that the WAN interface is part of the cluster.
Make sure the WAN interfaces on the two appliances are configured with
a static IP address of a matching subnet.
n
The cluster SYNC interface:
l
Use an Ethernet cross-cable to connect SYNC interfaces on the two
appliances.
l
By default, the LAN2 interfaces are used for cluster synchronization.
l
It is not necessary to configure an IP address on the LAN2 interface
at any stage of the gateway side configuration.
If you do not configure an IP address on the LAN2 interface, the IP
addresses of the SYNC interfaces are automatically set to
10.231.149.1 and 10.231.149.2.
l
If you manually configure IP addresses on the SYNC interfaces, you
must configure these IP addresses to be on the same subnet.
l
You can use a different SYNC interface other than LAN2. For more
information, see sk52500.
n
To configure IP addresses on interfaces other than WAN and LAN1, do so
in each gateway's WebUI - on the Internet or Local Network pages. Make
sure that for each interface that is part of the cluster, you configure an IP
address in the same subnet as the peer cluster member.
n
One-time password:
l
Remember this one-time password. You need it to configure the
cluster object in SmartConsole.
l
The one-time password must be the same on the two cluster
members to create the cluster object in Wizard Mode.
l
If the one-time password is not the same on the two cluster
members, you must create the cluster object in Classic Mode.
8. Reboot the first Quantum Spark appliance.
9. Shut down the first Quantum Spark appliance.
10. Connect the second Quantum Spark appliance to the power source and turn it on.
11. Connect your computer to the second Quantum Spark appliance to the LAN1 interface.
12. Renew the dynamic IP address on your computer.
13. In a web browser on your computer connect to:
http://my.firewall
To Next Page
Loading...
