Managing Device Settings
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Centrally Managed Administration Guide|70
You can install the firmware with one of these options:
n
Immediately - Installs the firmware in two steps:
l
Downloads the firmware immediately during the next synchronization with a
Security Gateway that references this profile.
l
Installs the firmware when the download completes.
n
According to time ranges - You can define download and installation time ranges for the
firmware image. The download and installation time can be limited to a specified list of
time ranges in the week. They start at the nearest time range after firmware settings
were applied. You can also define that the download takes place immediately as above
and only installation is based on specified time ranges. For example, if the firmware
installation settings were applied on Sunday and there are two time ranges:
l
One range is set to Friday 00:00 to Saturday 00:00
l
One range is set to Wednesday 23:00 to Thursday 06:00
The firmware is installed between Wednesday 23:00 and Thursday 06:00.
If the Security Gateway did not succeed to download and/or install the firmware
during the nearest time range, it tries again in the next time range.
To configure firmware installation settings in a Provisioning Profile:
1. Open the Security Gateway Profile window, and select the Firmware tab.
2. Select Manage firmware centrally from this application.
3. Click Advanced.
The Profile Settings window is displayed.
4. Select an override profile setting:
n
Allowed
n
Denied
n
Mandatory
For more information about override profile settings, see
"Configuring RADIUS" on
page72
below.
5. In Firmware image, click Select to select a firmware image that was uploaded through
SmartUpdate.
To Next Page
Loading...
