Managing Device Settings
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Centrally Managed Administration Guide|71
6. In Default SmartLSM Profile after installation, select the new SmartLSM profile of the
Security Gateway (the Security Gateway version must match its SmartLSM profile's
version as defined in SmartConsole for correct policy behavior). The Security Gateway
replaces its SmartLSM profile after successful firmware installation and only if the new
firmware version is different from the version you have now.
7. If necessary, click Exceptions to select a new SmartLSM profile for Security Gateways
with a specified SmartLSM profile.
n
Add/Edit - Click Add or Edit to open the Exceptions window to define/change an
exception for a SmartLSM profile replacement. SmartLSM profiles is not shown
unless they are from a version higher than R71.
l
Current SmartLSM Profile - Select a SmartLSM profile from the list. A
SmartLSM profile is shown only if the version is not R71 and not the selected
firmware version. Make sure you installed a policy for the SmartLSM profile in
SmartConsole.
l
SmartLSM Profile after installation - Select a SmartLSM profile that
replaces the SmartLSM profile after the firmware image installation. A
SmartLSM profile is shown only if the version is the same as the selected
firmware version. Make sure you installed a policy for the SmartLSM profile in
SmartConsole.
n
Remove - Click to remove a SmartLSM profile exception setting.
8. Select an option to install the firmware:
n
Immediately - Downloads the firmware immediately but installs it in the next
synchronization with a Security Gateway that references this profile.
n
According to these time ranges - Select to use the Security Gateway time or local
time.
l
Add/Edit - Click Add or Edit to open the Time Range window to
define/change the weekdays and times for downloading and installing the
firmware image. Select the days and times and click OK.
l
Remove - Select a range from the list and click Remove to delete a time
range.
l
Download image immediately - Click this option to download the firmware
image immediately but install the image during one of the set time ranges.
9. Click Show profile settings - To see the settings of the Provisioning Profile that this
gateway references.
10. Click OK.
To Next Page
Loading...
