Chroma 19032 - Page 110

Electrical Safety Analyzer 19032 User’s Manual
5-44
Example: Input command SAFE:PRES:NUM:PART "19032"
Description: This command sets the part number of the product to 19032.
[:SOURce]:SAFEty:PRESet:NUMber:PART?
This command queries the part number of the product.
Example: Input command “SAFE:PRES:NUM:PART?”
Return message “19032”
Description: Return message “19032” means the part number of the product is
19032.
[:SOURce]:SAFEty:PRESet:NUMber:LOT < string data >
This command sets the lot number of the product.
Example: Input command “SAFE:PRES:NUM:LOT 0032”
Description: This command sets the lot number of the product to 0032.
[:SOURce]:SAFEty:PRESet:NUMber:LOT?
This command queries the lot number of the product.
Example: Input command “SAFE:PRES:NUM:LOT?”
Return message “0032”
Description: Return message “0032” means the lot number of the product is 0032.
[:SOURce]:SAFEty:PRESet:NUMber:SERIal < string data >
This command sets the serial number format of the product. A changeable
character is denoted by “*”.
Example: Input command “SAFE:PRES:NUM:SERI AAP190320***”
Description: This command sets the serial number format of the product to
AAP190320***.
[:SOURce]:SAFEty:PRESet:NUMber:SERIal?
This command queries the serial number format of the product.
Example: Input command “SAFE:PRES:NUM:SERI?”
Return message “AAP190320***”
Description: Return message “AAP190320***” means the serial number format of
the product is AAP190320***.
[:SOURce]:SAFEty:PRESet:IEC < boolean > | ON | OFF
This command sets the IEC-601 function to ON or OFF.
Example: Input command “SAFE:PRES:IEC ON”
Description: This command sets the IEC-601 function to ON.
[:SOURce]:SAFEty:PRESet:IEC?
This command queries if the IEC-601 is ON or OFF.
Example: Input command “SAFE:PRES:IEC?”
Return message “1”
Description: Return message “1” means the IEC-601 is set to ON.
[:SOURce]:SAFEty:PRESet:RJUDgmnet < boolean > | ON | OFF
This command sets Ramp Judg. to ON or OFF.
Example: Input command “SAFE:PRES:RJUD ON”
Description: This command sets Ramp Judg. to ON.
[:SOURce]:SAFEty:PRESet:RJUDgment?
This command queries if Ramp Judg. is O N or O FF.
Example: Input command “SAFE:PRES:RJUD?”