xii
Revision History
The following lists the additions, deletions and modifications in this manual at each revision.
Modify “Inspection and Examination”
Modify “Inspection and Examination”
“Notice Items before Use”
“Remote Command Description”
“Each Parameters Setting Description”
“Test Parameter and Example”
“GPIB/RS-232 Operation Description (IEEE-488.2)”
Add “Standard Capacitance Value (GET Cs) Description”
Modify “Display Area Magnification” and “Simplified Function
Flow Chart” in the section of “Front Panel”.
Modify the figure 4-3 in the section of “Rear Panel”.
Modify the “SYSTEM SETUP” menu and “System parameter
setting data description” in the section of “System Parameter
Modify the “PRESET SETUP” menu and the table “Test ing
preset parameter function description” in the section of “Simple
Modify the figure 4-4 and figure 4-5 in the section of “Auto
Range”.
Modify the figure 4-6, 4-7, 4-8, 4-9 and 4-10 in the section of
“Start Wait Function”.
Modify descriptions of “Ground Resistance Test Mode (GB)”,
“Withstanding Voltage Test Mode (AC)”, “Withstanding Voltage
Test Mode (DC)”, “Insulation Resistance Test Mode (IR)” and
“Open/Short Circuit Detection Mode (OSC)” in the section of
“Each Parameters Setting Description”.
Modify the description of “KEY LOCK setting method” in the
section of “KEY LOCK Function”.
Modify the figure 4-11 and “Note” in the section of “FAIL LOCK
Setting and Using”.
Modify the figure 4-16, 4-17, 4-18, 4-19, 4-20, 4-21, 4-22, 4-23
and 4-24 in the section of “Single Test Mode”.
Modify the “STEP 1-3” menu in the section of “Auto Mode
Setting”
Modify “SCPI Commands” in the section of “Remote Command
Summary”.
Modify “<item> character data list” in the section of “Remote
To Next Page
Loading...
