xiii
Modify “Firmware Update Version” in the section of “Firmware
Update”.
Add the chapter of “The Description of GPIB/RS-232 Interface
(IEEE-488.1)”.
– the description of Disposal in “Storage, Freight,
– the description of “Operable range” in the section of
“Specifications”.
– “Figure 3-1” and the description of “Storage” in the section
of “Notice Items before Use”.
– “Figure 4-2” and “Figure 4-3” in the section of “Rear Panel”.
– the figure of “Test Step” in the section of “Auto Mode
Setting”.
– “25Pin change to 9Pin” in the section of “Cable Wiring
Pattern”.
– Modify the descriptions of RS-232/GPIB command in the
section of “Remote Command”.
Add the section of “Connector”
Add “Material Contents Declaration”
Delete the description of Disposal in “Storage, Freight,
Maintenance & Disposal”.
– “EMC” Verification of conformity and “TUV” Test Report.
– item 37 to 40 of the table in the section of “IEEE-488.1
Command List”.
– descriptions of item 6 to 11 in the section of “Description of
Modify the following sections:
– Standard accessory table in “Inspection and Examination”.
– description in the section of “An Overview of Product”.
– description in the section of “Features”.
– description of “20.Storage” in the section of “Notice Items
before Use”.
– description of item (3), (9) and (10) in the section of “Rear
Panel”.
– “SYSTEM SETUP” screen in the section of “System
Parameter Setting”.
– “PRESET SETUP” screen and description table in the
section of “Simple Setting Wizard”.
– Figure 4-4 and 4-5 in the section of “Auto Range”.
– Figure 4-6, 4-7, 4-8, 4-9 and 4-10 in the section of “Start
Wait Function”.
– description in the section of “Each Parameters Setting
Description”.
– Figure 4-11 in the section of “FAIL LOCK Setting and
Using”.
– display and description in the section of “Test Parameter
and Example”.
– SCPI command in the section of “Remote Command
Summary”.
– description in the section of “Remote Command
To Next Page
Loading...
