HIPOT Tester 19051/19052/19053/19054 User’s Manual
4.3 Notice Items and Procedures before Operation
1. Before plugging AC power cable, please confirm power that use firstly and description of
rear panel is match or not and power switch is OFF status.
2. Before turning on power, please peruse "Chapter 3 - Notice Items Before Using" and
remember it.
3. When turns on power, the tester will self-test. If there is abnormal condition, please
turns off switch and pulls off power cord immediately.
4.4 System Parameter Setting
4.4.1 How to Enter System Parameter Setting Menu
1. Under power on menu, press Function Key MENU the menu as the following:
1. MEMORY
UP
2. SYSTEM
3. OPTION
DOWN
4. CALIBRATION
5. KEY LOCK
SELECT
SELECT FUNC. RMT LOCK OFST ERR
EXIT
2. Move the highlighted to "SYSTEM" by Function Key UP, DOWN. Press Function Key
SELECT to enter system parameter setting menu is shown as the following:
1. CONTRAST : 3
UP
2. BEEPER VOL. : HIGH
3. DC 50V AGC : OFF
DOWN
ENTER
1-16 RMT LOCK OFST ERR
EXIT
4.4.2 Operation Methods
1. After entering system parameter setting menu, press Function Key ENTER to move the
highlighted to the parameter item, which want to set.
2. Press Function Keys UP, DOWN to set this item parameter data.
4-4
www.valuetronics.com
To Next Page
Loading...
