Automatic Transformer Test System 3300/3302 User’s Manual
Above is multi-sets testing. Press [Start] to return to single set testing.
Above parameters are described as following:
1 - 2 : The first level pin setting
3 – 4 : The secondary turn of the transformer
STANDARD : The standard value of each turn
HI LIMIT : The judgment of the Hi-Limit value
LO LIMIT : The judgment of the Lo-Limit value
LK. 1…9 : The testing set of the leakage inductance
TRANSFORMER : Pin position of the transformer
FIXTURE : The pin on transformer reflects to the fixture
The following screen is setting for JUDGMENT OF LEAKAGE INDUCTANCE of the
transformer. It is still a guidable operation what just following the method of the display to
key in the testing parameter and finish it by pressing [Enter] to jump to next testing item. As
above, by pressing [Enter] of the last item on each screen, the unit will jump to next setting
screen automatic. The positions of 1 – 2, 3 – 4 as above figure, if the system setting is
shown pins, then show the pins set. If the user desire to change the setting on each
back-light, the values may change by pressing the key which under the Cursor.
Above parameters are described as following:
1 - 2 : The first level pin setting.
3 – 4 : The secondary turns of the transformer
STANDARD : The standard value of each turn
HI LIMIT : The judgment of the Hi-Limit value
LO LIMIT : The judgment of the Lo-Limit value
To Next Page
Loading...
