Chroma 3300 - test frequency and voltage

Application of Interface
5-9
Then press [Enter] to enter next setting screen as below: (test frequency and voltage).
When into this screen is entrance to the setting of test parameter the same is still guidable
operation, just according the block area on the screen and number keys to input the test
parameter, press [Enter] then automatically change to next setting item, use the same method
till the last item on the same screen, press [Enter] then automatically change to next the
setting screen of parameter.
Ex: the test conditions of transformer are following:
TR: 20KHz /1V Lx: 1KHz /1V DCR: need to test
LK: 20KHz /1V Cx: 1KHz /1V PS : need to test
BL: need to test
The input is following:
TURN : [20] [ENTER] [1] [ENTER] [✓ ] [ENTER]
LX : [1] [ENTER] [1] [ENTER] [✓ ] [ENTER]
LK : [20] [ENTER] [1] [ENTER] [✓ ] [ENTER]
CX : [1] [ENTER] [1] [ENTER] [✓ ] [ENTER]
ACR : [X] [ENTER] [ENTER]
Zx : [X] [ENTER]
DCR : [✓ ] [ENTER] [ENTER]
PS : [✓ ] [ENTER]
BL : [✓ ] [ENTER]
HV : [X] [ENTER]
After finish the input, the screen is as below: