AutoPark will engage when all of these conditions are
met:
•
Vehicle is equipped with a gear selector
•
Vehicle is not in PARK
•
Vehicle speed is 1.2 mph (1.9 km/h) or less
•
Driver’s door is ajar
•
Driver’s seat belt is unbuckled
•
Brake pedal is not pressed
The message “ AutoPark Engaged” will display in the
instrument cluster.
AutoPark In Stop/Start Autostop Mode
AutoPark will engage when all of these conditions are
met:
•
Vehicle is equipped with a gear selector
•
Vehicle is not in PARK
•
Vehicle speed is 1.2 mph (1.9 km/h) or less
•
Driver’s door is ajar
•
Driver’s seat belt is unbuckled or brake pedal is not
pressed
The message “ AutoPark Engaged” will display in the
instrument cluster.
WARNING!
•
Never use the PARK (P) position as a substitute for
the parking brake. Always apply the parking brake
fully when exiting the vehicle to guard against
vehicle movement and possible injury or damage.
•
Your vehicle could move and injure you and others
if it is not in PARK. Check by trying to move the
transmission gear selector out of PARK with the
brake pedal released. Make sure the transmission
is in PARK before exiting the vehicle.
(Continued)
WARNING!
•
The transmission may not engage PARK if the
vehicle is moving. Always bring the vehicle to a com-
plete stop before shifting to PARK, and verify that
the transmission gear position indicator solidly indi-
cates PARK without blinking. Ensure that the vehicle
is completely stopped, and the PARK position is
properly indicated, before exiting the vehicle.
•
It is dangerous to shift out of PARK or NEUTRAL if
your foot is not firmly pressing the brake pedal.
The vehicle could accelerate quickly forward or in
reverse. You could lose control of the vehicle and
hit someone or something. Only shift into gear
when your foot is firmly pressing the brake pedal.
•
Unintended movement of a vehicle could injure
those in or near the vehicle. As with all vehicles,
you should never exit a vehicle while the engine is
running or the propulsion system is active. Before
exiting a vehicle, always come to a complete stop,
then apply the parking brake, shift the transmis-
sion into PARK, and turn the ignition OFF. When
the ignition is in the OFF position, the transmission
is locked in PARK, securing the vehicle against
unwanted movement.
•
When leaving the vehicle, always make sure the
ignition is in the OFF position, remove the key fob
from the vehicle, and lock the vehicle.
•
Never leave children alone in a vehicle, or with
access to an unlocked vehicle. Allowing children to
be in a vehicle unattended is dangerous for a num-
ber of reasons. A child or others could be seriously
or fatally injured. Children should be warned not to
touch the parking brake, brake pedal or the trans-
mission gear selector.
(Continued)
WARNING!
•
Do not leave the key fob in or near the vehicle (or
in a location accessible to children), and do not
leave the ignition in the ACC or ON/RUN position. A
child could operate power windows, other controls,
or move the vehicle.
CAUTION!
Damage to the transmission may occur if the follow-
ing precautions are not observed:
•
Shift into PARK or into or out of REVERSE only
after the vehicle has come to a complete stop.
•
Before shifting into any gear, make sure your foot
is firmly pressing the brake pedal with the excep-
tion of shifting between DRIVE and LOW. Shifting
between DRIVE and LOW can occur without any
brake application.
Achieving Propulsion System Active (PSA) Using
ENGINE START/STOP Button
1. The transmission must be in PARK or NEUTRAL.
2. Press and hold the brake pedal while pushing the
ENGINE START/STOP button once.
To release the parking brake manually, the ignition
switch must be in the ON/RUN position. Press on the
brake pedal, then push the parking brake switch
momentarily.
124 STARTING AND OPERATING
To Next Page
Loading...
