REAR BLOWER CONTROL
The rear blower control can be manually set
to off, or any fixed blower speed by pushing
the blower control buttons. This allows the
rear seat occupants to control the volume of
air circulated in the rear of the vehicle. The larger of the
two icons increases blower speed, whereas the smaller
of the two icons decreases the blower speed.
REAR MODE CONTROL
Push this button on the Rear Climate Con-
trols to change the air distribution mode for
the rear passengers.
PANEL MODE
Air comes from the outlets in the headliner.
Each of these outlets can be individually
adjusted to direct the flow of air. Moving the
air vanes of the outlets to one side will shut
off the airflow.
BI-LEVEL MODE
Air comes from both the headliner outlets
and the floor outlets.
NOTE:
In many temperature positions, the Bi-Level mode is
designed to provide cooler air out of the headliner out-
lets and warmer air from the floor outlets.
FLOOR MODE
Air comes from the floor outlets.
REAR CLIMATE CONTROL/BLOWER OFF
To manually set the rear blower controls to
off, press the Rear Climate Control/Blower
Off button.
MANUAL CLIMATE CONTROL
DESCRIPTIONS AND FUNCTIONS
MAX A/C Button
Press and release the MAX A/C button to
change the current setting. The indicator
illuminates when MAX A/C is on. Performing
this function again will cause the MAX A/C
operation to switch into manual mode and the MAX A/C
indicator will turn off.
NOTE:
The MAX A/C setting is only available on the
touchscreen.
A/C Button
Press and release the A/C button to change
the current setting. The indicator illuminates
when A/C is on.
NOTE:
•
For Manual Climate Controls, if the system is in Mix,
Floor or Defrost Mode, the A/C can be turned off,
but the A/C system shall remain active to prevent
fogging of the windows.
•
If fog or mist appears on the windshield or side
glass, select Defrost mode, and increase blower
speed if needed.
•
If your air conditioning performance seems lower
than expected, check the front of the A/C condenser
(located in front of the radiator), for an accumula-
tion of dirt or insects. Clean with a gentle water
spray from the front of the radiator and through the
condenser.
Recirculation Button
Press and release this button to change the
system between recirculation mode and out-
side air mode. The Recirculation indicator
and the A/C indicator illuminate when the
Recirculation button is pressed. Recirculation can be
used when outside conditions such as smoke, odors,
dust, or high humidity are present. Recirculation can be
used in all modes except for Defrost. Recirculation may
be unavailable (button on the touchscreen grayed out)
if conditions exist that could create fogging on the
inside of the windshield. The A/C (Air Conditioning) can
be deselected manually without disturbing the mode
control selection.
Uconnect 5 With 7-inch Display Manual Temperature
Controls
72 GETTING TO KNOW YOUR VEHICLE
To Next Page
Loading...
