Do NOT grab the door handle when pushing the door
handle button. This could unlock the door(s).
NOTE:
•
After pushing the door handle lock button, you must
wait two seconds before you can lock or unlock the
doors, using either Passive Entry door handle. This
is done to allow you to check if the vehicle is locked
by pulling the door handle, without the vehicle
unlocking.
•
If Passive Entry is disabled using the Uconnect Set-
tings, the key fob protection described in "Frequency
Operated Button Integrated Key (FOBIK-Safe)"
remains active/functional.
•
The Passive Entry system will not operate if the key
fob battery is depleted.
To Unlock/Enter The Liftgate
The liftgate Passive Entry unlock feature is built into the
electronic liftgate release handle. With a valid Passive
Entry key fob within 5 ft (1.5 m) of the liftgate, push the
electronic liftgate release handle for a power open on
vehicles equipped with Power Liftgate. Pull the elec-
tronic liftgate handle and lift for manual liftgate
vehicles
page 318.
AUTOMATIC UNLOCK DOORS ON
EXIT — IF EQUIPPED
The Unlock Doors Automatically On Exit feature unlocks
all of the vehicle doors when any door is opened. This
will occur only after the gear selector has been placed
into the PARK position, after the vehicle has been
driven (the gear selector has been placed out of PARK
and all doors closed).
The Unlock Doors Automatically On Exit feature will not
operate if there is any manual operation of the door
locks (lock or unlock).
This feature can be turned on or off in the Uconnect
system
page 169.
MANUAL SLIDING SIDE DOOR
The sliding door may be opened from the inside or the
outside. Pull outward on the exterior handle to open the
sliding door. The sliding door inside handle functions by
rocking forward and back. Rocking the handle back-
wards opens the door and rocking forward releases the
hold open latch in order to close the door.
NOTE:
If equipped with power sliding doors, using the manual
door handle will activate the power opening/closing
function. Allow the door to open or close fully on its
own, without forcing it.
To keep your door operating properly, observe the fol-
lowing guidelines:
•
Always open the door smoothly.
•
Avoid high impacts against the door stop when
opening the door. This is very important when your
vehicle is parked on an incline as the door will slide
faster in the downhill direction.
Do NOT Grab The Door Handle When Locking
Electronic Liftgate Release Handle
Side Door Handle And Lock Functions
1 — Door Handle
2 — Door Lock
GETTING TO KNOW YOUR VEHICLE 33
2
To Next Page
Loading...
