NOTE:
•
It is the driver’s responsibility to maintain a clear
line of sight with the instrument cluster display for
driving instructions during a parking maneuver.
•
It is the driver's responsibility to use the brake and
accelerator during the semi-automatic parking
maneuver.
•
It is the driver's responsibility to use the brake and
stop the vehicle. The driver should check their sur-
roundings and be prepared to stop the vehicle either
when instructed to, or when driver intervention is
required.
•
When the system instructs the driver to remove their
hands from the steering wheel, the driver should
check their surroundings and begin to back up
slowly. All instructions will appear in the instrument
cluster display.
•
The ParkSense Active Park Assist system will allow a
maximum number of shifts between DRIVE and
REVERSE. If the maneuver cannot be completed
within six shifts, the system will cancel and the
instrument cluster display will instruct the driver to
complete the maneuver manually.
•
The system will cancel the maneuver if the vehicle
speed exceeds 5 mph (7 km/h) during active steer-
ing guidance into the parking space. The system will
provide a warning to the driver at 3 mph (5 km/h)
that tells them to slow down. The driver is then
responsible for completing the maneuver if the sys-
tem is canceled.
•
If the system is canceled during the maneuver for
any reason, the driver must take control of the
vehicle.
WARNING!
Drivers must be careful when performing parallel or
perpendicular parking maneuvers even when using
the ParkSense Active Park Assist system. Always
check carefully behind and in front of your vehicle,
look behind and in front of you, and be sure to check
for pedestrians, animals, other vehicles, obstructions,
and blind spots before backing up and moving for-
ward. You are responsible for safety and must con-
tinue to pay attention to your surroundings. Failure to
do so can result in serious injury or death.
CAUTION!
•
The ParkSense Active Park Assist system is only a
parking aid and it is unable to recognize every
obstacle, including small obstacles. Parking curbs
might be temporarily detected or not detected at
all. Obstacles located above or below the sensors
will not be detected when they are in close
proximity.
•
The vehicle must be driven slowly when using the
ParkSense Active Park Assist system in order to be
able to stop in time when an obstacle is detected.
It is recommended that the driver looks over his/
her shoulder when using the ParkSense Active
Park Assist system.
LANESENSE — IF EQUIPPED
LANESENSE OPERATION
The LaneSense system is operational at speeds above
37 mph (60 km/h) and below 112 mph (180 km/h). It
uses a forward facing camera to detect lane markings
and measure vehicle position within the lane
boundaries.
When both lane markings are detected and the driver
drifts out of the lane (no turn signal applied), the Lane-
Sense system provides a haptic warning in the form of
torque applied to the steering wheel, as well as a visual
warning in the instrument cluster display, to prompt the
driver to remain within the lane boundaries.
The driver may manually override the haptic warning by
applying force to the steering wheel at any time.
When only a single lane marking is detected and the
driver unintentionally drifts across that lane marking
(no turn signal applied), the LaneSense system pro-
vides a visual warning through the instrument cluster
display to prompt the driver to remain within the lane.
When only a single lane marking is detected, a haptic or
a torque warning will not be provided.
NOTE:
When operating conditions have been met, the Lane-
Sense system will monitor if the driver’s hands are on
the steering wheel and provide an audible and visual
warning to the driver when the driver’s hands are not
detected on the steering wheel. The system will cancel
if the driver does not return their hands to the wheel.
152 STARTING AND OPERATING
To Next Page
Loading...
