When the HI-level setting is selected, the heater will
provide a boosted heat level during the initial stages of
operation. Then, the heat output will drop to the normal
HI-level. The level of heat selected will stay on until the
operator changes it.
VENTILATED SEATS — IF EQUIPPED
Located in the first row seat cushions are
small fans that draw the air from the passen-
ger compartment and move air through fine
perforations in the seat cover to help keep the
driver and front passenger cooler in higher ambient tem-
peratures. The fans operate at two speeds: HI and LO.
The front ventilated seats control buttons are located in
the touchscreen.
•
Press the ventilated seat button once to choose HI.
•
Press the ventilated seat button a second time to
choose LO.
•
Press the ventilated seat button a third time to turn
the ventilated seat off.
NOTE:
The engine must be running for the ventilated seats to
operate.
For information on use with the Remote Start system,
see
page 26.
PLASTIC GROCERY BAG RETAINER
HOOKS
Retainer hooks which will hold plastic grocery bag
handles are built into the seatbacks of the second row
rear seats, and if equipped, the backs of the front row
seats. The floor supports the partial weight of the
bagged goods.
HEAD RESTRAINTS
Head restraints are designed to reduce the risk of injury
by restricting head movement in the event of a rear
impact. Head restraints should be adjusted so that the
top of the head restraint is located above the top of
your ear.
WARNING!
•
All occupants, including the driver, should not oper-
ate a vehicle or sit in a vehicle’s seat until the
head restraints are placed in their proper positions
in order to minimize the risk of neck injury in the
event of a crash.
•
Head restraints should never be adjusted while the
vehicle is in motion. Driving a vehicle with the head
restraints improperly adjusted or removed could
cause serious injury or death in the event of a
collision.
Head Restraints — Front Seats
The front driver and passenger seats are equipped with
four-way head restraints.
To raise the head restraint, pull upward on the head
restraint. To lower the head restraint, push the adjust-
ment button, located at the base of the head restraint,
and push downward. The front head restraints are also
adjustable forward and rearward. To tilt forward, pull
the top of the head restraint toward the front of the
vehicle to the desired position. To adjust the head
restraint rearward, continue pulling forward on the top
of the head restraint to the farthest forward position
and the head restraint will return to the upright
position.
NOTE:
To remove the head restraint, raise it as far as it can go.
Then, push the release button and the adjustment but-
ton at the base of each post while pulling the head
restraint up. Seatback angle may need to be adjusted
to fully remove the head restraint. To reinstall the head
restraint, put the head restraint posts into the holes
and push downward. Then, adjust the head restraint to
the appropriate height.
Front Head Restraint
1 — Release Button
2 — Adjustment Button
GETTING TO KNOW YOUR VEHICLE 53
2
To Next Page
Loading...
