WARNING!
•
A loose head restraint thrown forward in a collision
or hard stop could cause serious injury or death to
occupants of the vehicle. Always securely stow
removed head restraints in a location outside the
occupant compartment.
(Continued)
WARNING!
•
ALL the head restraints MUST be reinstalled in the
vehicle to properly protect the occupants. Follow
the reinstallation instructions prior to operating the
vehicle or occupying a seat.
Head Restraints — Second Row Quad
Seats
The second row outboard head restraints, as well as
the removable 8th passenger seat (if equipped), may
have adjustable head restraints.
NOTE:
If equipped with Stow ‘n Go seating, the head restraints
are non-adjustable and non-removable. Do not pull on
non-adjustable head restraints when folding the seat.
To raise the head restraint, pull upward on the head
restraint. To lower the head restraint, push the adjust-
ment button, located at the base of the head restraint,
and push downward.
To remove the head restraint, raise it as far as it can go.
Then, push the release button and the adjustment but-
ton at the base of each post while pulling the head
restraint up. Seatback angle may need to be adjusted
to fully remove the head restraint. To reinstall the head
restraint, put the head restraint posts into the holes
and push downward. Then, adjust the head restraint to
the appropriate height.
Head Restraints — Third Row
The outboard head restraints can be manually folded
forward for improved rearward visibility. Pull the release
strap to fold them forward.
NOTE:
•
The head restraints must be raised manually when
occupying the third row.
•
Do not fold if there are passengers seated in the
third row seats.
The head restraint in the center position can be raised
and lowered for tether routing or height adjustment
page 207.
NOTE:
To remove the center head restraint, raise it as far as it
can go. Then, push the release button and the adjust-
ment button at the base of each post while pulling the
head restraint up. To reinstall the head restraint, put
the head restraint posts into the holes and push down-
ward. Then, using the adjustment button, adjust the
head restraint to the appropriate height.
Normal Position
Forward Adjustment
Release Straps
54 GETTING TO KNOW YOUR VEHICLE
To Next Page
Loading...
