NOTE:
When using a portable battery booster pack, follow the
manufacturer’s operating instructions and precautions.
WARNING!
Do not attempt jump starting if the battery is frozen. It
could rupture or explode and cause personal injury.
CAUTION!
Do not use a portable battery booster pack or any
other booster source with a system voltage greater
than 12 Volts or damage to the battery, starter motor,
alternator or electrical system may occur.
PREPARATIONS FOR JUMP START —
GAS MODELS
The battery in your vehicle is located on the driver’s
side of the engine compartment.
WARNING!
•
Take care to avoid the radiator cooling fan when-
ever the hood is raised. It can start anytime the
ignition switch is ON. You can be injured by moving
fan blades.
•
Remove any metal jewelry such as rings, watch
bands and bracelets that could make an inadver-
tent electrical contact. You could be seriously
injured.
(Continued)
WARNING!
•
Batteries contain sulfuric acid that can burn your
skin or eyes and generate hydrogen gas which is
flammable and explosive. Keep open flames or
sparks away from the battery.
NOTE:
The positive battery post may be covered with a protec-
tive cap. Lift up on the cap to gain access to the posi-
tive battery post. Do not jump off fuses. Only jump
directly off positive post which has a positive (+) symbol
on or around the post.
See the following steps to prepare for jump starting:
1. Apply the parking brake, shift the automatic trans-
mission into PARK (P) and place the ignition to OFF.
2. Turn off the heater, radio, and all electrical
accessories.
3. Pull upward and remove the protective cap over the
positive (+) battery post.
4. If using another vehicle to jump start the battery,
park the vehicle within the jumper cable’s reach, set
the parking brake and make sure the ignition is OFF.
WARNING!
Do not allow vehicles to touch each other as this
could establish a ground connection and personal
injury could result.
JUMP STARTING PROCEDURE —
GAS MODELS
WARNING!
Failure to follow this jump starting procedure could
result in personal injury or property damage due to
battery explosion.
CAUTION!
Failure to follow these procedures could result in
damage to the charging system of the booster vehicle
or the discharged vehicle.
Connecting The Jumper Cables
1. Connect the positive (+) end of the jumper cable to
the positive (+) post of the vehicle with the dis-
charged battery.
2. Connect the opposite end of the positive (+) jumper
cable to the positive (+) post of the booster battery.
3. Connect the negative (-) end of the jumper cable to
the negative (-) post of the booster battery.
Battery Location
IN CASE OF EMERGENCY 255
7
To Next Page
Loading...
