WARNING!
•
Persons who are unable to feel pain to the skin
because of advanced age, chronic illness, diabe-
tes, spinal cord injury, medication, alcohol use,
exhaustion, or other physical conditions must exer-
cise care when using the steering wheel heater. It
may cause burns even at low temperatures, espe-
cially if used for long periods.
•
Do not place anything on the steering wheel that
insulates against heat, such as a blanket or steer-
ing wheel covers of any type of material. This may
cause the steering wheel heater to overheat.
DRIVER MEMORY SETTINGS —
IF EQUIPPED
This feature allows the driver to save up to two different
memory profiles for easy recall through a memory
switch. Each memory profile saves desired position set-
tings for the following features:
•
Driver’s seat
•
Easy Entry/Exit seat operation (if equipped)
•
Side mirrors (if equipped)
•
A set of desired radio station presets
NOTE:
•
Your vehicle is equipped with two key fobs, each can
be linked to either memory position 1 or 2.
•
Memory settings will be linked to the driver profiles
in the Uconnect system, in addition to several other
features (radio presets, home screens, settings,
navigation, phone, etc.)
page 169.
The Driver Memory Settings switch is located on the
driver door, next to the door handle, and consists of
three buttons:
•
The set (S) button, which is used to activate the
memory save function.
•
The (1) and (2) buttons which are used to recall
either of two saved memory profiles.
PROGRAMMING THE MEMORY
FEATURE
To create a new memory profile, perform the following:
NOTE:
Saving a new memory profile will erase the selected
profile from memory.
1. Place the vehicle’s ignition in the ON/RUN position
(do not start the engine).
2. Adjust all memory profile settings to desired prefer-
ences (i.e., driver’s seat, outside mirrors and radio
station presets).
3. Push the set (S) button on the memory switch, and
then push the desired memory button (1 or 2) within
five seconds. The instrument cluster display will
show which memory position has been set.
NOTE:
Memory profiles can be set without the vehicle in PARK.
LINKING AND UNLINKING THE KEY
FOB TO MEMORY
Your key fob can be programmed to recall one of two
saved memory profiles.
NOTE:
Before programming your key fob you must select the
“Personal Settings Linked to Key Fob” feature through
the Uconnect Settings
page 169.
To program your key fob, perform the following:
1. Place the vehicle’s ignition in the OFF position.
2. Select a desired memory profile 1 or 2.
3. Once the profile has been recalled, push and
release the set (S) button on the memory switch.
4. Push and release button (1) or (2) accordingly.
“Memory Profile Set” (1 or 2) will display in the
instrument cluster.
5. Push and release the lock button on the key fob
within 10 seconds.
Driver Memory Switch
1 — Memory Profile Button 1
2 — Memory Profile Button 2
3 — Set Button
GETTING TO KNOW YOUR VEHICLE 37
2
To Next Page
Loading...
