ENGINE OIL FILTER
The engine oil filter should be replaced with a new filter
at every engine oil change.
Engine Oil Filter Selection
A full-flow type disposable oil filter should be used for
replacement. The quality of replacement filters varies
considerably. Only high quality Mopar® certified filters
should be used. If Mopar® Engine Oil Filters are
unavailable only use filters that meet or exceed SAE/
USCAR-36 Filter Performance Requirements.
ENGINE AIR CLEANER FILTER
For the proper maintenance intervals page 264.
WARNING!
The air induction system (air cleaner, hoses, etc.) can
provide a measure of protection in the case of engine
backfire. Do not remove the air induction system (air
cleaner, hoses, etc.) unless such removal is neces-
sary for repair or maintenance. Make sure that no
one is near the engine compartment before starting
the vehicle with the air induction system (air cleaner,
hoses, etc.) removed. Failure to do so can result in
serious personal injury.
Engine Air Cleaner Filter Selection
The quality of replacement filters varies considerably.
Only high quality Mopar® certified filters should be
used.
ACCESSORY DRIVE BELT
INSPECTION
WARNING!
•
Do not attempt to inspect an accessory drive belt
with vehicle running.
•
When working near the radiator cooling fan, dis-
connect the fan motor lead. The fan is temperature
controlled and can start at any time regardless of
ignition mode. You could be injured by the moving
fan blades.
•
You can be badly injured working on or around a
motor vehicle. Only do service work for which you
have the knowledge and the proper equipment. If
you have any doubt about your ability to perform a
service job, take your vehicle to a competent
mechanic.
When inspecting accessory drive belts, small cracks
that run across the ribbed surface of a belt from rib to
rib, are considered normal. These are not a reason to
replace belt. However, cracks running along a rib (not
across) are not normal. Any belt with cracks running
along a rib must be replaced. Also, have the belt
replaced if it has excessive wear, frayed cords, or
severe glazing.
Conditions that would require replacement:
•
Rib chunking (one or more ribs has separated from
belt body)
•
Rib or belt wear
•
Longitudinal belt cracking (cracks between two ribs)
•
Belt slips
•
Groove jumping (belt does not maintain correct posi-
tion on pulley)
•
Belt broken
NOTE:
Identify and correct problem before new belt is
installed
•
Noise (objectionable squeal, squeak, or rumble is
heard or felt while drive belt is in operation).
Some conditions can be caused by a faulty component
such as a belt pulley. Belt pulleys should be carefully
inspected for damage and proper alignment.
Belt replacement on some models requires the use of
special tools; we recommend having your vehicle ser-
viced at an authorized dealer.
Accessory Belt (Serpentine Belt)
270 SERVICING AND MAINTENANCE
To Next Page
Loading...
