3. Place the Tire Service Kit in its proper storage area
in the vehicle.
4. Have the tire inspected and repaired or replaced at
the earliest opportunity at an authorized dealer or
tire service center.
5. Remove the Speed Limit sticker from the steering
wheel after the tire has been repaired.
6. Replace the Sealant Bottle at an authorized dealer
as soon as possible.
NOTE:
When having the tire serviced, advise the authorized
dealer or service center that the tire has been sealed
using the Tire Service Kit.
Sealant Bottle Replacement:
1. Unwrap the power cord.
2. Unwrap the hose.
3. Remove the bottle cover.
4. Rotate the bottle up beyond vertical to release.
5. Pull the bottle away from the Compressor.
NOTE:
•
For sealant bottle installation, follow these steps in
reverse order.
•
Replacement sealant bottles are available at autho-
rized service centers.
JUMP STARTING — GAS MODELS
If your vehicle has a discharged battery it can be jump
started using a set of jumper cables and a battery in
another vehicle or by using a portable battery booster
pack. Jump starting can be dangerous if done improp-
erly so please follow the procedures in this section
carefully.
NOTE:
When using a portable battery booster pack follow the
manufacturer’s operating instructions and precautions.
Jump starting can be dangerous if done improperly so
please follow the procedures in this section carefully.
Hose Location
Remove The Bottle Cover
Rotate The Bottle Up
Remove The Bottle
254 IN CASE OF EMERGENCY
To Next Page
Loading...
