3. To abort seat operation while seat is in motion, push
a different seat position selector switch to stop the
seat. Once the seat stops moving, then the desired
position can be selected.
4. The third row power seat system includes obstacle
detection. When the system detects an obstacle, the
motors will stop and reverse direction. Should this
occur, remove the obstacle before pushing the but-
ton again.
NOTE:
•
You may experience deformation in the seat cushion
from the seat belt buckles, or wrinkling of the seat
fabric if the seats are left folded for an extended
period of time. This is normal and by simply unfold-
ing the seats to the open position, over time the
seat cushion may return to its normal shape. Having
an occupant sit in the seat, or massaging the fabric
by hand may smooth away any excess wrinkling.
•
Permanent wrinkles may still result.
HEATED SEATS
Front Heated Seats — If Equipped
The front heated seats control buttons are
located in the touchscreen.
You can choose from HI, LO or off heat set-
tings. The indicator lights in each switch indi-
cate the level of heat in use. Two indicator lights will
illuminate for HI, one for LO and none for off.
•
Press the heated seat button once to turn the HI
setting on.
•
Press the heated seat button a second time to turn
the LO setting on.
•
Press the heated seat button a third time to turn the
heating elements off.
The level of heat selected will stay on until the operator
changes it.
NOTE:
•
Once a heat setting is selected, heat will be felt
within two to five minutes.
•
The engine must be running for the heated seats to
operate.
For information on use with the Remote Start system,
see
page 26.
WARNING!
•
Persons who are unable to feel pain to the skin
because of advanced age, chronic illness, diabe-
tes, spinal cord injury, medication, alcohol use,
exhaustion or other physical condition must exer-
cise care when using the seat heater. It may cause
burns even at low temperatures, especially if used
for long periods of time.
•
Do not place anything on the seat or seatback that
insulates against heat, such as a blanket or cush-
ion. This may cause the seat heater to overheat.
Sitting in a seat that has been overheated could
cause serious burns due to the increased surface
temperature of the seat.
Rear Heated Seats — If Equipped
On some models, the second row seats are equipped
with heaters. There are two heated seat switches that
allow the second row passengers to operate the seats
independently. The heated seat switches are located on
the sliding side door handle trim panels.
You can choose from HI, LO or off heat settings. Amber
indicator lights in each switch indicate the level of heat
in use. Two indicator lights will illuminate for HI, one for
LO and none for off.
Push the switch once to select HI-level heating. Push
the switch a second time to select LO-level heating.
Push the switch a third time to shut the heating ele-
ments off.
NOTE:
Once a heat setting is selected, heat will be felt within
two to five minutes.
Second Row Heated Seat Switch (Left Side Shown)
52 GETTING TO KNOW YOUR VEHICLE
To Next Page
Loading...
