Chrysler PACIFICA 2024 - Page 53

NOTE:
The third row power recline buttons can be locked out
using the Third Row Lockout setting within the
Uconnect system
page 169.
Third Row Power Stow ‘n Go Seat —
If Equipped
A one-touch power folding seat switch is located in the
right rear trim panel as part of a switch bank.
NOTE:
The third row outboard seat belts may interfere with the
power folding of the seat. Place the seat belt webbing
behind the stow clip before stowing or opening the seat.
When the seat is in the desired position, remove the
webbing from the stow clip so that it is ready for use.
Never leave the seat belt in the stow clip when it is
used to restrain an occupant.
NOTE:
•
The outer head restraints will lower automatically as
necessary when the power seat begins to move.
•
The center head restraint raises and lowers manu-
ally but will not lower automatically.
•
The head restraint can also be lowered manually
using the pull strap located at the back of the seat
page 55.
The switch is only functional when the liftgate is open
and the vehicle is in PARK.
The rear switch bank allows multiple power folding and
unfolding positions for the third row seats.
Left and right third row seats can be folded individually
or together. The third row power folding seat adjusts to
the following positions using the switch bank located on
the left rear trim panel:
To move the selected seat(s) to the normal (seated)
position, push and release the “Normal” button. The
seat will automatically stop when the Normal position is
reached.
To move the selected seat(s) to the stow position, push
and release the “Stow” button. The seat will automati-
cally stop when the Stow position is reached.
To move the selected seat(s) back in the forward or
reverse direction, push and hold the “Fold Forward/
Back” button. Release the button when the desired
position is reached.
1. Disconnect the center shoulder belt from the mini-
buckle before attempting to fold/stow the power
third row seats.
2. Before pushing the “Normal” or “Stow” button, place
the outboard seat belt webbing behind the stow
clips, located on the rear trim panel. When the seat
reaches the desired position, remove the webbing
from the clip so it is ready for use to restrain an
occupant.
Third Row Power Seat Switch
Rear Panel Power Switch Bank
1 — Open To Normal
2—Stow
3 — Fold Forward/Rearward
4 — Right/Left Seats/Both Seats
Seat Belt Stowage Clip
GETTING TO KNOW YOUR VEHICLE 51
2