•
This message will be displayed continuously
•
Cannot be cleared with button press
•
A continuous and rapid chime will sound.Stop and
park the vehicle in an open area. Have all passen-
gers exit the vehicle as soon as possible and move to
a safe distance away from the vehicle. After all pas-
sengers safely exit the vehicle, call emergency
responders immediately. Even if you do not see
flames, a fire may start at any moment, so do not
attempt to re-enter or start the vehicle.
ENGINE OIL LIFE
Use this QR code to access your digital
experience.
•
Your vehicle is equipped with an
engine oil change indicator system.
The “Oil Change Required” message
will display for approximately five
seconds after a single chime has sounded, to indi-
cate it is time to change the engine oil. The engine
oil change indicator system is duty cycle based,
which means the engine oil change interval may
fluctuate, dependent upon your personal driving
style.
•
Unless reset, this message will continue to display
each time the ignition is cycled to the ON/RUN
position.
•
To reset the oil change indicator after performing
the scheduled maintenance, refer to the following
procedure.
NOTE:
This procedure should only be performed after sched-
uled maintenance is completed. Resetting oil life other
than when associated with a scheduled maintenance
may result in damage due to not properly maintaining
the engine oil.
Oil Life Reset
1. Without pressing the brake pedal, push the ENGINE
START/STOP button and place the ignition in the
ON/RUN position (do not start the vehicle.)
2. Push the OK button to enter the instrument cluster
display menu screen.
3. Push and release the down
arrow button to
access the ”Vehicle Info” menu screen.
4. Push the left
arrow button or right arrow but-
ton to access the “Oil Life” submenu.
5. Hold the OK button to reset the “Oil Life” to 100%.
6. Push the up
arrow button to exit the instrument
cluster display menu screen.
Secondary Method For Oil Life Reset Procedure
1. Without pushing the brake pedal, place the ignition
in the ON/RUN position (do not start the engine).
2. Fully press the accelerator pedal, slowly, three times
within 10 seconds.
3. Without pushing the brake pedal, place the ignition
in the OFF position.
NOTE:
If the indicator message illuminates when you start the
vehicle, the oil change indicator system did not reset. If
necessary, repeat this procedure.
INSTRUMENT CLUSTER DISPLAY
MENU ITEMS
The instrument cluster display can be used to view the
main menu items for several features. Use the up
and down arrow buttons to scroll through the
driver interactive display menu options until the desired
menu is reached
page 103.
NOTE:
The instrument cluster display menu items display in
the center of the instrument cluster. Menu items may
vary depending on your vehicle features.
Speedometer
Push and release the up or down arrow button
until Speedometer is highlighted in the instrument clus-
ter display. Push and release the OK button to toggle
between MPH and km/h.
Vehicle Info
Push and release the up or down arrow button
until Vehicle Info is highlighted in the instrument cluster
display. Push the left
or right arrow button to
scroll through the following information submenus:
Tire Pressure Monitor
If tire pressure is correct for all tires, a vehicle icon is
displayed with tire pressure values in each corner of the
ICON.
If one or more tires have low pressure, “Inflate Tire To
XX” is displayed with the vehicle ICON, and the tire pres-
sure values in each corner of the ICON with the pres-
sure value of the low tire displayed in a different color
than the other tire pressure value.
Scan me
GETTING TO KNOW YOUR INSTRUMENT PANEL 105
3
To Next Page
Loading...
