If the Tire Pressure system requires service, “Service
Tire Pressure System” is displayed.
Tire PSI is an information only function and cannot be
reset
page 205.
Coolant Temp
Displays the actual coolant temperature.
Transmission Temp
Displays the actual transmission temperature.
Oil Temp — If Equipped
Displays the actual oil temperature.
Oil Pressure
Displays the actual oil pressure.
Oil Life
Displays the remaining engine oil life as a percentage.
To reset the Oil Life, you must hold the OK button. The
“Hold OK to Reset” instruction will be displayed at all
times, but the following conditions will need to be met
in order to reset Oil Life:
•
The ignition must be in the ON/RUN position.
If the conditions are met, holding the OK button will
reset the gauge and the numeric display will return to
100%.
If the conditions are not met, a pop-up message will
display for five seconds, describing the required condi-
tions, and then the Oil Life screen will reappear.
Battery Voltage
Displays the actual battery voltage.
Engine Hours — If Equipped
Displays the number of hours of engine operation.
Driver Assist — If Equipped
Push and release the up or down arrow button
until Driver Assist is highlighted in the instrument clus-
ter display.
Adaptive Cruise Control and LaneSense:
•
Driver Assist Screen shows the current status of
both the ACC and the LaneSense systems
•
Pop-up messages also indicate the status of the
system and/or the conditions that need to be met
Adaptive Cruise Control (ACC) Feature
The instrument cluster display will show the current ACC
system settings. The information displayed depends on
ACC system status. Push the Adaptive Cruise Control
(ACC) on/off button (located on the steering wheel) until
one of the following displays in the instrument cluster
display:
•
Adaptive Cruise Control Off: when ACC is deacti-
vated, the display will read “Adaptive Cruise Control
Off.”
•
Adaptive Cruise Control Ready: when ACC is acti-
vated but the vehicle speed setting has not been
selected, the display will read “Adaptive Cruise Con-
trol Ready.” Push the SET + or the SET- button
(located on the steering wheel).
ACC SET
When ACC is set, the set speed will display in the instru-
ment cluster.
The ACC screen may display once again if any ACC activ-
ity occurs, which may include any of the following:
•
Distance Setting Change
•
System Cancel
•
Driver Override
•
System Off
•
ACC Proximity Warning
•
ACC Unavailable Warning
For further information, refer to “Adaptive Cruise Con-
trol (ACC) — If Equipped” in “Starting And Operating” in
the Owner’s Manual.
LaneSense — If Equipped
The instrument cluster displays the current LaneSense
system settings. The information displayed depends on
LaneSense system status and the conditions that need
to be met.
For further information, refer to “LaneSense —
If Equipped” in “Starting And Operating” in the Owner’s
Manual.
Hybrid Info
Push and release the up or down arrow button
until Hybrid Info is highlighted in the instrument cluster
display. Push the left
or right arrow button to
scroll through the following information submenus:
Energy Economy
•
Average MPG gauge + value (hold OK to reset)
•
Current Energy Economy gauge + value
•
Total Range
Range to Empty
•
Electric Range
•
Hybrid Range
•
Total Range
106 GETTING TO KNOW YOUR INSTRUMENT PANEL
To Next Page
Loading...
