CAUTION!
Use care when removing and handling the crossbars
to prevent damage to the vehicle.
2. Bend the crossbar supports at each end, taking
care to keep hand clear of pivoting joint. Slide the
thumb screw down.
3. Position the crossbars across the roof making sure
the letters on the crossbars align with the matching
letters on the side rail.
4. Once the crossbar is in place, tighten both thumb
screws completely.
5. Deploy and tighten the second crossbar to complete
the deployment of the crossbars.
NOTE:
The crossbars are not identical and have fixed deploy-
ment positions. Rear crossbar can be deployed in two
different positions.
STOWING THE CROSSBARS
1. Starting with one crossbar, completely loosen the
thumb screws at both ends. Lift the crossbar away
from the matching letter to remove it from the
deployed position. Repeat with the other crossbar.
CAUTION!
Use care when removing and handling the crossbars
to prevent damage to the vehicle.
2. Starting with the one crossbar, bend up the pivot
supports at each end.
Bending Pivot
Positioning Crossbars
Installing Cr ossbars
Crossbar Pivot
96 GETTING TO KNOW YOUR VEHICLE
To Next Page
Loading...
