NOTE:
Do not cut or splice wiring into the vehicle’s wiring
harness.
The electrical connections are all complete to the
vehicle but you must mate the harness to a trailer con-
nector. Refer to the following illustrations.
NOTE:
•
Disconnect the trailer wiring connector from the
vehicle (or any other device plugged into vehicle’s
electrical connectors) before launching a boat into
water.
•
Be sure to reconnect once clear from water area.
TOWING TIPS
Before towing, practice turning, stopping, and backing
up the trailer in an area located away from heavy traffic.
Automatic Transmission
Select the DRIVE range when towing. The transmission
controls include a drive strategy to avoid frequent shift-
ing when towing. For increased engine braking on steep
downhill grades, select the LOW range.
Cruise Control — If Equipped
•
Do not use on hilly terrain or with heavy loads.
•
When using the Cruise Control, if you experience
speed drops greater than 10 mph (16 km/h), disen-
gage until you can get back to cruising speed.
•
Use Cruise Control in flat terrain and with light loads
to maximize fuel efficiency.
TRAILER TOWING — HYBRID MODELS
(IF EQUIPPED)
Trailer towing is not permitted with this vehicle.
Four-Pin Connector
1 — Ground
2—Park
3 — Left Stop/Turn
4 — Right Stop/Turn
Seven-Pin Connector
1 — Backup Lamps
2 — Running Lamps
3 — Left Stop/Turn
4 — Ground
5 — Battery
6 — Right Stop/Turn
7 — Electric Brakes
166 STARTING AND OPERATING
To Next Page
Loading...
