2. Open the small access panel on the upper right
side, and unclip the hose from the hose access port
by pushing the yellow vacuum hose release lever
with right thumb and lifting the hose with index
finger.
3. Return to vacuum nozzle storage location located
behind the sliding door.
4. Grab the vacuum nozzle and gently pull the hose
out through vacuum nozzle storage location.
5. Shake the hose to remove any objects stuck in the
hose. Take care not to perforate the hose while
attempting to dislodge any objects.
6. Reverse the procedure to reinstall and clip the hose
into place.
STOW ‘N PLACE ROOF RACK —
IF EQUIPPED
The crossbars and side rails are designed to carry
weight on vehicles equipped with a luggage rack. The
load must not exceed 150 lb (68 kg), and should be
uniformly distributed over the luggage rack crossbars.
The crossbars on your vehicle are delivered stowed
within the roof rack side rails. Crossbars should always
be used whenever cargo is placed on the roof rack.
Check the straps frequently to be sure that the load
remains securely attached.
The Stow ‘n Place roof rack does not increase the total
load carrying capacity of the vehicle. Be sure the total
load of cargo inside the vehicle plus that on the exter-
nal rack does not exceed the maximum vehicle load
capacity.
DEPLOYING THE CROSSBARS
1. To deploy the crossbars, completely loosen the
thumb screws at both ends of the crossbar and lift
the crossbar from its stowed position in the side rail.
Repeat with crossbar on the opposite side.
NOTE:
The thumb screws cannot be fully removed.
Vacuum Hose Release Lever
Roof Rack
1—SideRail
2 — Crossbar
Thumb Screw
Removing Crossbars
GETTING TO KNOW YOUR VEHICLE 95
2
To Next Page
Loading...
