Vacuum Troubleshooting
•
DO NOT use with any opening blocked. If an object
becomes lodged in the hose, attempt to fully extend
the hose in a straight line while the vacuum motor is
running. If this does not dislodge the object, turn the
vacuum OFF and remove the hose from the vehicle
using the subsequent removal instructions. If the
filter is clogged, follow the emptying debris bin pro-
cedure and lightly tap the filter on the collection bin
to remove any collected debris from the filter. Both
the bin and the filter can be rinsed with water if
needed. To avoid mold and stale odors, allow both
to dry completely before reinstalling in your vehicle.
If the filter has tears, holes or other damage and
needs to be replaced, please contact an authorized
dealer.
•
If there are any other issues with your vacuum, con-
tact an authorized dealer. Your vacuum has no user
serviceable parts.
Debris Bin
The debris bin is located behind the access panel
behind the third row seat on the driver’s side.
To Empty
1. Push power button to turn vacuum OFF.
2. Open the access panel by pulling the finger grip
towards you and then pull downward.
3. Twist the release knob counterclockwise and pull
the bin towards you.
4. Remove the filter and dump the debris in a trash
can. Lightly tap the filter on the collection bin to
remove loose debris from the filter. If the filter is
clogged from extended use, have the filter replaced
by an authorized dealer.
5. Reverse the procedure to reinstall.
NOTE:
The debris bin must be fully installed and locked for the
vacuum to function properly.
Hose Access Port
The hose access port is located behind the access
panel behind the third row seat on the driver’s side.
To Remove Vacuum Hose For Cleaning
1. Open the access panel.
Vacuum System Access Panel
Debris Bin Release Knob
Vacuum System Access Panel
94 GETTING TO KNOW YOUR VEHICLE
To Next Page
Loading...
