WARNING!
Leaving the Adaptive Cruise Control (ACC) system on
when not in use is dangerous. You could accidentally
set the system or cause it to go faster than you want.
You could lose control and have a collision. Always
leave the system off when you are not using it.
To Set A Desired Speed
When the vehicle reaches the speed desired, push the
SET (+) button or the SET (-) button and release. The
instrument cluster display will show the set speed.
NOTE:
Fixed Speed Cruise Control can be used without ACC
enabled. To change between the different modes, push
the ACC on/off button which turns the ACC and the
Fixed Speed Cruise Control off. Pushing the Fixed
Speed Cruise Control on/off button will result in turning
on (changing to) Fixed Speed Cruise Control mode.
WARNING!
In Fixed Speed Cruise Control mode, the system will
not react to vehicles ahead. In addition, the proximity
warning does not activate and no alarm will sound
even if you are too close to the vehicle ahead since
neither the presence of the vehicle ahead nor the
vehicle-to-vehicle distance is detected. Be sure to
maintain a safe distance between your vehicle and
the vehicle ahead. Always be aware which mode is
selected.
If ACC is set when the vehicle speed is below 20 mph
(32 km/h), the set speed will default to 20 mph
(32 km/h).
NOTE:
Fixed Speed Cruise Control cannot be set below
20 mph (32 km/h).
If either system is set when the vehicle speed is above
20 mph (32 km/h), the set speed shall be the current
speed of the vehicle.
NOTE:
•
Keeping your foot on the accelerator pedal can
cause the vehicle to continue to accelerate beyond
the set speed. If this occurs, the message “Driver
Override” will display in the instrument cluster
display.
•
If you continue to accelerate beyond the set speed
while an ACC is enabled, the system will not be con-
trolling the distance between your vehicle and the
vehicle ahead. The vehicle speed will only be deter-
mined by the position of the accelerator pedal.
To Cancel
The following conditions cancel the ACC or Fixed Speed
Cruise Control systems:
•
The brake pedal is applied
•
The CANC (cancel) button is pushed
•
The Anti-Lock Brake System (ABS) activates
•
The gear selector is removed from the DRIVE
position
•
The Electronic Stability Control/Traction Control Sys-
tem (ESC/TCS) activates
•
The vehicle parking brake is applied
•
The braking temperature exceeds normal range
(overheated)
The following conditions will only cancel the ACC
system:
•
Driver seat belt is unbuckled at low speeds
•
Driver door is opened at low speeds
To Turn Off
The system will turn off and clear the set speed in
memory if:
•
The Adaptive Cruise Control (ACC) on/off button is
pushed
•
The Fixed Speed Cruise Control on/off button is
pushed
•
The ignition is placed in the OFF position
To Resume
If there is a set speed in memory, push the RES
(resume) button and then remove your foot from the
accelerator pedal. The instrument cluster display will
display the last set speed.
Resume can be used at any speed above 20 mph
(32 km/h) when only Fixed Speed Cruise Control is
being used.
NOTE:
•
If your vehicle is at a standstill longer than two sec-
onds, the driver will either have to push the RES
(resume) button, or apply the accelerator pedal to
reengage the Adaptive Cruise Control (ACC) to the
existing set speed.
•
ACC cannot be resumed if there is a stationary
vehicle in front of your vehicle in close proximity.
140 STARTING AND OPERATING
To Next Page
Loading...
