•
FCW may not react to irrelevant objects such as
overhead objects, ground reflections, objects not in
the path of the vehicle, stationary objects that are
far away, oncoming traffic, or leading vehicles with
the same or higher rates of speed.
•
FCW will be disabled like ACC, with the unavailable
screens.
FCW Limited Warning
If the instrument cluster displays “ACC/FCW Limited
Functionality”, “FCW Limited Functionality”, “ACC/FCW
Limited Functionality Clean Front Windshield”, or “FCW
Limited Functionality Clean Front Windshield” momen-
tarily, there may be a condition that limits FCW function-
ality. Although the vehicle is still drivable under normal
conditions, the active braking may not be fully available.
Once the condition that limited the system performance
is no longer present, the system will return to its full
performance state. If the problem persists, see an
authorized dealer.
Service FCW Warning
If the system turns off, and the instrument cluster
displays:
•
ACC/FCW Unavailable Service Required
•
FCW Unavailable Service Required
This indicates there is an internal system fault.
Although the vehicle is still drivable under normal condi-
tions, have the system checked by an authorized
dealer.
Pedestrian Emergency Braking (PEB) —
If Equipped
PEB is a subsystem of the FCW system which provides
the driver with audible and visual warnings in the instru-
ment cluster display, and may apply automatic braking
when it detects a potential frontal collision with a
pedestrian/cyclist.
If a PEB event begins at a speed below 37 mph
(60 km/h), the system may provide braking to mitigate
the potential collision with a pedestrian/cyclist. If the
PEB event stops the vehicle completely, the system will
hold the vehicle at a standstill for two seconds and then
release the brakes. When the system determines a col-
lision with the pedestrian/cyclist in front of you is no
longer probable, the warning message will be
deactivated.
The minimum speed for PEB activation is 3 mph
(5 km/h).
WARNING!
Pedestrian Emergency Braking (PEB) is not intended
to avoid a collision on its own, nor can PEB detect
every type of potential collision with a pedestrian/
cyclist. The driver has the responsibility to avoid a
collision by controlling the vehicle via braking and
steering. Failure to follow this warning could lead to
serious injury or death.
Turning PEB On Or Off
NOTE:
The default status of PEB is “On.” This allows the sys-
tem to warn you of a possible frontal collision with the
pedestrian/cyclist.
The PEB button is located in the Uconnect display in the
Controls settings
page 169.
To turn the PEB system off, push the Pedestrian Emer-
gency Braking OFF button.
To turn the PEB system back on, push the Warning
Active Braking button.
Changing the PEB status to “Off” deactivates the sys-
tem, so no warning or active braking will be available in
case of a possible frontal collision with the
pedestrian/cyclist.
NOTE:
The PEB system will NOT retain the last setting selected
by the driver after ignition shut down. The system will
reset to the default setting when the vehicle is
restarted.
PEB Message
204 SAFETY
To Next Page
Loading...
