Output
not used 0
Limit_max_freq_out
Table 1 Range and configuration of the output analogue
The equipment has 6 analogues inputs to send SETPOINT values to the equipment in ANALOG
machine setpoints control. The configuration of this control mode must be done through the
local control LCD touchscreen.
The input analogue values are used to send SETPOINT (SP) to the equipment: there are two input
analogue related to each output channel of the power converter; it means that SETPOINT U1
and U2 are used to send SP for channel U.
On the Table 2 it is shown which are the SETPOINT range of each input analogue depend on the
control mode of the equipment.
To Next Page
Loading...
