GE+ ACDC Installation and operation manual v11
75 / 121
1. Enable and disable the independent branch control. The selected mode is illuminated in
yellow.
2. There is the possibility to work with the phases U and V both in voltage mode. To do so,
a software PID can be activated with this button to get a balance in the current flowing
in both voltage source channels.
V. HW Check
For now, this is an internal option of Cinergia and is in development process to be available for
the user as soon as possible.
VI. Config.
In this tab, the user can introduce the general and specific parameters into the equipment:
Each submenu is described below:
a. Input Conf.
The input configuration allows to choose the control of the equipment. It is separated with two
parts: the machine control and the setpoints control. The machine control are the signals which
To Next Page
Loading...
