GE+ ACDC Installation and operation manual v11
77 / 121
c. Digital. This option allows to control the converter using the digitals signals
gathered in the X17 DB15 connector in the front panel connections which its
pinout is the following:
The converter will follow the instructions coming from the selected option.
While there is a selected control, the other two controls are not available.
The Machine Setpoints Control (2) is separated in two options:
a. Modbus. The setpoints are sent using the interface delivered by Cinergia.
b. Analog. The setpoints are sent using the DB15 connector gathered in X15.
B) With Power Amplifier. It is almost the same as the option without power amplifier, but
the setpoints can be sent via Modbus and Power Amplifier. This last option is explained
in the manual of the equipment and it means that the user can introduce the desired
waveform in the X15 connector and it will appear in the output.
b. Output Conf.
This window allows the user to set the analogue outputs. Each channel has 2 analogue outputs
(for example, output U has analogue outputs U1 and U2) and each output can be configured as
To Next Page
Loading...
