Configuring BFD Dampening for TE Tunnels 224
Configuring Periodic LSP Ping Requests 225
Configuring BFD at the Tail End 226
Configuring BFD over LSP Sessions on Line Cards 227
Configuring BFD Object Tracking: 228
Configuration Examples for Configuring BFD 229
BFD Over BGP: Example 229
BFD Over OSPF: Examples 229
BFD Over Static Routes: Examples 230
BFD on Bundled VLANs: Example 230
BFD on Bundle Member Links: Examples 231
Echo Packet Source Address: Examples 232
Echo Latency Detection: Examples 233
Echo Startup Validation: Examples 233
BFD Echo Mode Disable: Examples 233
BFD Dampening: Examples 234
BFD IPv6 Checksum: Examples 234
BFD Peers on Routers Running Cisco IOS and Cisco IOS XR Software: Example 235
Configuring BFD IPv6 Multihop: Examples 235
BFD over MPLS TE LSPs: Examples 236
BFD over MPLS TE Tunnel Head-end Configuration: Example 236
BFD over MPLS TE Tunnel Tail-end Configuration: Example 236
Where to Go Next 236
Additional References 236
Related Documents 237
Standards 237
RFCs 237
MIBs 237
Technical Assistance 238
CHAPTER 4
Implementing EIGRP 239
Prerequisites for Implementing EIGRP 240
Restrictions for Implementing EIGRP 240
Information About Implementing EIGRP 240
EIGRP Functional Overview 240
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.1.x
OL-30423-03 xi
Contents
To Next Page
Loading...
