Cisco ASR 9000 Series Configuration Guide

Configuring LDP IGP Synchronization: OSPF
Perform this task to configure LDP IGP Synchronization under OSPF.
By default, there is no synchronization between LDP and IGPs.Note
SUMMARY STEPS
1.
configure
2.
router ospf process-name
3.
Use one of the following commands:
•
mpls ldp sync
•
area area-id mpls ldp sync
•
area area-id interface name mpls ldp sync
4.
commit
DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Identifies the OSPF routing process and
enters OSPF configuration mode.
router ospf process-name
Example:
RP/0/RSP0/CPU0:router(config)# router ospf 100
Step 2
Enables LDP IGP synchronization on an
interface.
Use one of the following commands:
Step 3
•
mpls ldp sync
•
area area-id mpls ldp sync
•
area area-id interface name mpls ldp sync
Example:
RP/0/RSP0/CPU0:router(config-ospf)# mpls ldp sync
commit
Step 4
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.1.x
OL-30423-03 403
Implementing OSPF
Configuring LDP IGP Synchronization: OSPF

Cisco ASR 9000 Series Specifications

General

Brand	Cisco
Model	ASR 9000 Series
Category	Network Router
Language	English